Jump to content
Call us (951) 749-6477

Service · Riverside

Plumber for gas lines: installs, repairs, caps and moves

Gas piping is regulated work, and the person running it needs a California contractor license and, usually, a city permit. We arrange a visit from a local plumber who does gas work, and the quote comes in writing first.

Get a quote

Gas line from the meter with shutoff and earthquake valves, branching to a range, dryer and water heater

Notice a gas odor, a hissing sound, or a dead strip of lawn over a line? Get out of the building first. Once outside, phone SoCalGas on 1-800-427-2200, and ring 911 should anyone be in danger. Skip the light switches and any phone inside. Everything else on this page is for planned work, such as a new line for a range or dryer, a repair, a cap or a move. We pass your request to a local plumber for a visit; ask for a quote or see all our services on the home page.

Do plumbers put in gas lines?

Many do, though not all, so ask first. California requires a contractor license for any job worth $1,000 or more once labor and materials are counted, and for any job that requires a permit; new gas piping normally requires one. Before anyone starts cutting, check the license number at cslb.ca.gov, the CSLB website.

When you request a quote here, say the job involves gas. That way the plumbing business taking the request knows to send someone who does gas work. The job includes the pipe, a shutoff valve at every appliance, a flexible connector on the appliance end, followed by a pressure test ahead of putting the line into service. The old pipe, if a line is being replaced, gets capped or removed.

What does a gas line job cost?

Fixr's guide, updated August 29, 2025, puts gas line installation at $500 to $2,000, with an average near $800. Per linear foot it lists $10 to $20 for an extension, $15 to $25 for a new installation, and $23 to $35 for replacement. These are national guide figures. They are not Riverside rates and not what we charge, and only a written quote sets the price.

Three factors drive a gas job's price most: how long the run is, how difficult the pipe is to get to, and whether the gas company must do work at the meter. A short extension to a patio fire pit in an Orangecrest back yard is a smaller job than a new line through a finished wall in an older Eastside home. The cost page, gas line costs in Riverside, goes through the line items.

Who supplies natural gas here?

SoCalGas. Its list of cities served names Riverside, Moreno Valley and Loma Linda, plus communities such as Arlington, Casa Blanca, La Sierra, Edgemont, Highgrove, Sunnymead, Mead Valley and the March Air Reserve Base area. Orangecrest, Canyon Crest and Eastside are neighborhoods of the cities on that list, so the same utility applies.

Ask SoCalGas before any work near the meter, since where its responsibility ends and the property's begins is its call. A plumber works on the piping inside the property. If your address sits on the edge of a service area, SoCalGas says to confirm through its own maps page. For leaks and emergencies, the number is 1-800-427-2200.

Will a plumber extend gas to a range, dryer or fireplace?

Yes. Plumbers regularly run gas to a new range, a dryer, a gas fireplace, an outdoor grill or a fire pit, and tie in a water heater or tankless unit. Every appliance gets a shutoff valve of its own, on pipe sized correctly, because a longer run or more appliances means a larger diameter.

Gas log sets and fireplaces add a venting and clearance question on top of the pipe, and a city may inspect it. The cleaner path is to tell the plumber business what appliance you plan to install and where, and let the written quote spell out pipe size, valve and permit. The rules behind those answers are in our guide to residential gas piping codes. Flexible line follows separate rules, laid out in the half-inch flexible gas line page.

Is capping or relocating a gas line something a plumber does?

Capping and moving are routine jobs. A cap closes off a line that no longer feeds anything, say after a range is swapped for electric. A move reroutes the pipe to a new appliance location, a common step in a kitchen or bathroom remodel. Expect both to require a permit, so confirm with the city, and each should finish with a leak test.

Two panels: a closed gas stub with a cap, and a gas line rerouted to a new spot

Do not cap a line yourself and do not shut an appliance valve and call it done, because an unmarked, uncapped end can be opened by the next person. Before a remodel, tell the plumber about every gas appliance, including a gas dryer or a stub left behind by a previous owner. Gas often comes along with bathroom and kitchen work, and plumbing for a bathroom remodel covers the water side.

Book a plumber quote

Tell us about the job. We'll arrange a visit and a written quote before any work starts.

Lets the business see where the job is before they quote.

We earn a referral fee from the plumber who gets your job. You pay us nothing.

Where does a permit come in?

Gas piping changes generally need a permit in Riverside, and the plumber business usually pulls it. Moreno Valley and Loma Linda have their own offices, so ask them about your job. Per the City of Riverside's building division, installing, altering, repairing, removing, converting or replacing regulated plumbing, gas and mechanical systems takes a permit; call (951) 826-5800. Check your own job's requirement at the counter.

In Moreno Valley, call the Building and Safety Division on (951) 413-3350. For Loma Linda, permit questions go to (909) 799-2836. Addresses in unincorporated Highgrove, Mead Valley or Woodcrest may fall under the County of Riverside instead, at (951) 955-1800, so check which agency your address belongs to. The 2025 California codes took effect January 1, 2026, per Moreno Valley's own bulletin.

Does an earthquake shutoff valve count as a gas line job?

Yes, because it is a device on the line at the meter side. An automatic shutoff valve cuts the gas off once strong shaking is detected, and installing one is gas work with its own rules. Gas shutoff valves for quakes describes the device, and fitting a seismic gas shutoff valve walks through the install.

Do not do it yourself. Fitting the valve means working on a pressurized gas line. Leave it to a plumber experienced in gas work; the permit side is explained under permits, codes and inspections.

What should I check before choosing a gas plumber?

Begin with the license number, then ask who will really be on site, whether the quote comes in writing, and who pulls the permit. A good answer to each is specific. A vague answer to any is a reason to try someone else, as is a demand for cash before any materials show up.

California caps home improvement deposits, and any job of $500 or more needs a written contract. Ask for the scope, the materials, the price and the permit line on paper. Look up the contractor's history at cslb.ca.gov. Our page on best rated plumbers covers what to compare.

Common questions

How can I avoid being overcharged by a plumber?

Before work starts, get the scope and price on paper, verify the contractor's license at cslb.ca.gov, and be wary of a large up-front payment. California limits home improvement deposits. Get a second quote on anything big. A plumber who will not explain a charge in plain words, or who starts a permit job without mentioning the permit, is a plumber to walk away from.

What marks out a good plumber?

Good plumbers explain the problem and the options without hurry, show you the license number, quote in writing and say who pulls the permit. They answer about pipe sizing, shutoff valves and a pressure test with specifics. We do not rate or rank businesses, and we do not publish reviews. Judge by the answers you get and by the CSLB record.

What are the three types of plumbing?

Plumbing usually splits into three systems: the supply of drinking water, the drain-waste-vent network, and gas piping. Water lines bring clean water in under pressure, drain lines carry waste out by gravity, and gas lines feed appliances. Gas has the strictest rules of the three: a leak or bad joint can mean fire or explosion, so permits and pressure tests matter more.

What is the highest paid type of plumber?

We have no sourced pay data, so we will not name one. Pay depends on specialty, region and employer, and it is not a useful way to pick a plumber. What matters to a homeowner is whether the person doing your job holds the right California license and has done gas work like yours before.

What is the usual timeline for a gas line job?

A short extension or a cap is the smaller kind of job, and a longer run or a move behind finished walls takes longer. The plumber business tells you the schedule when it quotes. Permit and inspection timing add to the calendar, and the gas stays off at that appliance until the pressure test passes.

Guides in this section

  • 1/2 inch flexible natural gas line

    What a 1/2 inch flexible natural gas line is, where it is used, what limits it, and why gas piping in Riverside needs a contractor, a…

  • Earthquake gas valve

    Earthquake gas shut off valves for Riverside homes: how automatic valves work, what a plumber checks, what to do after a quake and who may…

  • Gas lines

    Who installs an earthquake gas shut off valve, why SoCalGas will not, how the work is permitted and what to ask for in the quote.

  • Costs

    Gas line prices from 2024 and 2025 guides: per-foot rates, what changes the total, and how to read a written quote for gas piping in…

Sources used

Page updated