Jump to content
Call us (951) 749-6477

What it costs ยท Riverside

Plumber inspection cost in Riverside, Moreno Valley and Loma Linda

Most plumbing inspections run about $100 to $225 in the one published guide we could read, and the figure changes with what is being looked at. This page sorts out which inspection you mean and who to call about the permit side.

Get a quote

Camera head on a cable pushed through a sewer line from a capped cleanout stub at ground level

"Inspection" means three different things in plumbing: a plumber looking over your pipes and fixtures, a camera or smoke test of a drain or sewer, and the city inspector who signs off permitted work. Only the first two are something you hire, and just one guide with a dollar figure was readable for this page. The permit side is covered on permits, codes and inspections, and other services are listed on the home page.

How much does a plumber inspection run?

The Fixr guide to hiring a plumber, updated January 30, 2025, says most inspections cost $100 to $225. Its full range starts at free, for a small job with the plumber already on site, and reaches $400 for a full inspection. These are national guide figures, not Riverside rates and not what we charge. The written quote sets the price.

A visual inspection looks at exposed pipes, fixtures, shutoff valves, water pressure, the water heater and signs of leaks. It often pays off before purchasing an older house, where steel and early copper lines may be close to worn out. When buying, ask the inspector or plumber what each line is made from and how old the heater is.

What do a camera inspection and a smoke test cost?

No readable published price turned up for either, so we will not quote one. In a camera inspection, a small camera travels down a drain or sewer line to reveal cracks, roots or sags. A smoke test sends harmless smoke through the drains to expose leaks in the vent or sewer system. Request the price from the plumber in writing.

Camera work helps most ahead of a sewer repair, because it shows where to dig and how the pipe is holding up. Roots in aging sewer laterals are a common reason to look. The city's Sewerage Systems Division runs the public sewers at (951) 826-5311, and the private lateral from your property to the main is for the owner to check. Pricing for finding leaks in supply lines is on the leak detection cost page.

How much does backflow testing cost?

We hold no sourced price for backflow testing, so none is quoted. A backflow preventer is a valve that stops dirty water from flowing backward into the drinking supply. Water suppliers often require periodic testing of these assemblies on irrigation systems, fire lines and some commercial properties. A qualified tester performs it, and the water utility or city sets how often.

Your water provider can say what applies. Riverside Public Utilities is at (951) 782-0330, Eastern Municipal Water District covers most of Moreno Valley, and the City of Loma Linda operates its own water. The procedure is explained on the pages for backflow prevention testing, how backflow testing is done, backflow testing services and commercial backflow testing.

At what point does plumbing work need a permit?

Generally whenever you add, move, replace or alter pipes, a water heater or a gas line. In the City of Riverside's handout, faucet or toilet repair or replacement is exempt, while replacing piping behind a wall face or under the floor needs a permit. A water heater swap in Riverside generally needs one too, and the city's counter number is (951) 826-5800.

Two boxes: pipe and water heater work needs a permit, faucet and toilet repairs usually do not

In Moreno Valley, call Building and Safety at (951) 413-3350, and for Loma Linda permit questions, (909) 799-2836. Whether Moreno Valley or Loma Linda require a permit for a water heater swap could not be verified, so ask them. Unincorporated areas such as parts of Highgrove or Mead Valley go through the County of Riverside, (951) 955-1800. Any job that needs a permit also needs a California contractor license.

How do I get a plumbing permit, and how long is it valid?

Normally the contractor pulls the permit, and the quote should state that. An owner doing exempt-adjacent work personally should visit the city's Building and Safety counter. The City of Riverside counter is at 3900 Main Street, 3rd Floor, open Monday to Friday 9:00 am to 4:00 pm, Wednesday 10:00 am to 4:00 pm. Moreno Valley's office is at 14177 Frederick Street.

Each city sets how long a permit stays valid, often depending on whether inspections continue. No verified figure turned up for any of the three, so ask the issuing office when you apply. Moreno Valley appears to offer online permits through a portal called SimpliCITY, but confirm with the city before relying on it.

Book a plumber quote

Tell us about the job. We'll arrange a visit and a written quote before any work starts.

Lets the business see where the job is before they quote.

We earn a referral fee from the plumber who gets your job. You pay us nothing.

What is the best way to compare inspection quotes?

Weigh what gets examined, how it is documented, and what you receive afterward. A solid inspection quote states whether a written report, photos or video, and a pressure reading are included, and whether the fee is credited toward a repair should you hire the same plumber. Compare two quotes on those points rather than on the bottom number.

Also ask what the inspection leaves out. Looking at exposed pipes cannot reveal what sits inside a wall or under a slab. A suspected hidden leak calls for a leak detection visit, which uses different tools. If you are deciding whether to buy a house, ask the inspector which items need a contractor's second look. Weighing hourly options? Read how much a plumber costs per hour.

Common questions

What is the typical length of an inspection?

The length depends on what is being examined. A visual house check, a camera run and a backflow test each have their own timing, and no published figure is available to quote. The plumbing business that takes your request supplies its own estimate. City inspections happen within the inspector's scheduled window.

Which questions should I put to someone hired to inspect plumbing?

Find out what is covered, whether a written report comes with it, how the price relates to a repair by the same plumber, and the contractor license number so you can check cslb.ca.gov. Ask how pressure is measured, since readings above 80 psi exceed the California Plumbing Code limit and shorten fixture life.

Should I be home for the inspection?

Yes. An adult should be home, or have someone present who can open up the water heater, the main shutoff, under-sink areas and any crawl space or panel. The inspector may need to run water at several fixtures. Being there lets you hear the findings and ask questions on the spot.

Is a free plumbing inspection really free?

Fixr notes an inspection can be free when the plumber is already there for a small job, so the free end of the range is real. A free inspection linked to a sales visit usually carries the expectation that you will hire that plumber. That is not wrong, but get a second quote on any big repair it uncovers.

Sources used

Page updated