Jump to content
Call us (951) 749-6477

What it costs ยท Riverside

What it costs to repipe a house in Riverside

National guides put repiping anywhere from about $1,500 to $15,000, and two published sources explain why. Here is what drives the range for houses in Riverside, Moreno Valley and Loma Linda.

Get a quote

Floor plan of a house with a new supply manifold feeding separate lines to the kitchen, bath and heater.

Repiping a whole house has no one price. Bob Vila's repipe guide, updated April 24, 2023, reports a national average of $7,500 within a typical span of $1,500 to $15,000. Its PEX vs. copper page, updated July 23, 2025, puts copper at $8,000 to $10,000 and PEX at $4,000 to $6,000 for a 1,500 square foot home with two baths. These are guide figures, not local rates. The work itself is described in repiping and pipe replacement.

What should I expect to pay to repipe a 2,000 square foot home?

None of the guides we read prints a firm 2,000 square foot number, and we will not make one up. The closest sources list copper at $8,000 to $10,000 and PEX at $4,000 to $6,000 for a two-bath house of 1,500 square feet. Expect a larger house with more fixtures and longer runs to land higher; the written quote sets the price.

Square footage is a weak predictor anyway. Two houses of the same size can differ a lot in price because of the number of bathrooms, whether the lines run through an attic or a slab, how many walls must be opened and whether a second story is involved. Tell the quoting business the fixture count and floor plan rather than the footage alone.

Is there a per-square-foot repipe rate, or a price for a small house?

Published guides here do not give a reliable per square foot rate, so avoid any website that quotes one with false precision. For materials alone, Bob Vila puts copper near $2 to $8 for each linear foot, while PEX is listed between $0.40 and $2 for the same length. A small house or condo with one bath sits toward the low end of the $1,500 to $15,000 span.

Repiping a single bathroom, or replacing one branch only, is cheaper than doing the whole house, yet each visit brings its own call-out, permit and patching costs. Sometimes doing it all at once is cheaper per fixture. Ask the quoting business to price the whole house and the partial job on separate lines so you can compare.

Scope Guide figure Source
Typical whole house $1,500 to $15,000, average $7,500 Bob Vila, April 24, 2023
PEX, two baths, 1,500 sq ft $4,000 to $6,000 Bob Vila, July 23, 2025
Copper, two baths, 1,500 sq ft $8,000 to $10,000 Bob Vila, July 23, 2025
Copper materials per foot $2 to $8 Bob Vila, April 24, 2023
PEX materials per foot $0.40 to $2 Bob Vila, April 24, 2023

Use the table to compare bids, not to budget to the dollar. The written quote sets the price.

What makes a repipe cost more in Riverside area homes?

Access, age and finishes move the bill most. Older houses can have plaster or older drywall, tight walls and sometimes galvanized lines, and every opened wall has to be repaired. Hillside homes can add slope and access difficulty, and two-story houses take longer.

Further drivers include how many bathrooms there are, which pipe material you pick, whether the water heater and shutoff valves are replaced in the same visit, and whether the main line running between meter and house is included. Permits and inspections add their own fees, and the city or county sets them, so quotes should list them.

Newer homes may be easier to work in, and some may already have PEX or CPVC. Before bids are compared, a camera inspection or pressure test can verify the contents of the walls.

Which option costs least when pipes are failing?

Spot repairs cost least, but a house with repeated pinhole leaks usually pays more over time. A targeted fix suits a case where one section has failed while the remainder passes testing. A full repipe is worth pricing once leaks have appeared in more than one place, water looks discolored, or pressure falls across the house.

Decision flow: one leak in one section means a spot repair, repeated leaks mean pricing a repipe.

When leaks begin under a slab, slab leak repair or repipe explains how to choose. Whether copper or PEX is the better value for your house is in the PEX vs copper comparison.

Is a permit needed for repiping, and who covers the fee?

The City of Riverside's exempt-work handout says piping replaced behind the face of a wall or below the floor needs a permit, and repiping is not on the exempt list. Moreno Valley, Loma Linda and the county set their own rules. California law requires a contractor license for any job that needs a permit or reaches $1,000 in labor and materials.

Permit fees are normally part of the quote, but ask whether they are listed separately. Do not accept a quote that says the permit is optional. An unpermitted repipe can create problems with insurance claims and when you sell the house.

What is the best way to weigh competing bids?

Ask each business for the same written scope: pipe type, number of fixtures, shutoff valves, water heater connections, drywall repair and paint, permit and inspection, start and finish dates, and what happens to water service each day. If one bid is far lower, check what it leaves out. California limits home improvement deposits, so ask what is due and when.

In the plumber cost guide you can see how hourly pricing and call-out charges feed into bigger bids. Building from scratch instead? The page on plumbing costs for a new house covers rough-in and finish stages. To begin, use the quote form, which is the fastest route.

Book a plumber quote

Tell us about the job. We'll arrange a visit and a written quote before any work starts.

Lets the business see where the job is before they quote.

We earn a referral fee from the plumber who gets your job. You pay us nothing.

Common questions

How many days does repiping last?

Duration varies with house size, wall access and pipe material, so we have no firm number to give. Plaster walls stretch the schedule. Water service stops for part of each day, and patching plus paint can outlast the pipework. Get the schedule, including water-off windows and who handles wall repair, in writing.

Does repiping pay off in an aging house?

It can be, when lines are failing in more than one place, water is discolored, or pressure has dropped house-wide. It is less clear when only one leak has appeared on otherwise sound pipe. Pressure testing and line inspection by a plumber lets you decide with facts rather than fear.

Which questions should I raise with a repipe bidder?

Ask who pulls the permit, which pipe and fittings go in, whether drywall repair is included, how many workers will be on site and how hidden damage is handled. Put scope, price and schedule in writing before the start. You can look up a business's contractor license status on the CSLB website.

Who has to be home while the pipes are replaced?

An adult needs to be around, because every bathroom, the kitchen, the water heater and the attic or crawl space need to be reachable. Expect stretches without running water, so line up showers, cooking and toilet use. Add any access notes to your request.

Sources used

Page updated