Having a plumber install a faucet is a short, small job, and a garbage disposal is somewhat bigger because of the sink connection and the power. The figures below come from national guides, not Riverside rates. Across the guides we read, faucet installation runs $150 to $1,350 and disposal installation $300 to $600. The repair side is explained in the faucet, sink, shower and disposal hub. For a price that fits your own sink, ask for a written quote.
What is the usual price to install a disposal?
In Fixr's guide, updated January 31, 2025, garbage disposal installation costs $300 to $600, averaging $500, with plumber labor near $300 of that. These are national figures from a guide, neither Riverside rates nor our prices. The total includes the unit unless you supply your own.
Several things move the price. Replacing an existing disposal is simplest, because the sink opening and wiring are already in place. Putting one into a sink that never had one means altering the drain and possibly adding an outlet. A bigger motor, a sound-insulated model or a countertop air switch adds to the parts cost.
The written quote sets the price. Learn whether the disposal itself is included, whether the old unit gets hauled away, and whether the quote assumes a power outlet already exists in the cabinet.
What lifespan can I expect from a disposal?
Guides publish a range of years, because motor size, daily use and what gets ground all play a part. No single authoritative lifespan figure turned up in our reading, so treat the manufacturer's warranty as a floor and replace the unit when it jams repeatedly, leaks from its housing or hums without turning.
Water seeping from the body, instead of a loose drain joint, normally means the housing has failed, and the fix is replacement. Grinding noises, a tripped reset button and slow drainage after grinding all signal wear. Before buying new, try the steps in clearing a clogged disposal drain.
What does it cost to install a faucet?
The faucet itself is often the largest part of the bill. The This Old House plumbing cost guide, updated 06/06/2026, gives $150 to $600 for faucet replacement. Fixr's bathroom sink guide, updated January 30, 2025, prices installed faucets by type: single hole $225 to $850, centerset $230 to $650 and widespread $280 to $1,350. Bob Vila's kitchen faucet guide of September 13, 2023, shows $260 to $480 for professional installation.
Once more, these are national guide figures rather than Riverside rates. A new faucet set into the existing holes costs less than one needing fresh supply lines, a bigger sink opening or a replacement stop valve. A seized stop valve is the most common extra, and with the cabinet already open, that is the cheapest moment to handle it.
For repair versus replace, faucet replacement goes deeper, and a leaky faucet fix shows when a new cartridge is enough.
How do the guide prices for these jobs compare?
Each dollar figure here is a national guide figure from the source named beside it. The table gathers them in one place, showing which guide said what and when it was last updated. Prices vary with the fixture and the sink, and several of these guides have changed since earlier years.
| Job | Guide range | Source and date |
|---|---|---|
| Faucet replacement | $150 to $600 | This Old House, 06/06/2026 |
| Faucet installed, by type | $225 to $1,350 | Fixr, January 30, 2025 |
| Kitchen faucet, professional install | $260 to $480 | Bob Vila, September 13, 2023 |
| Garbage disposal installation | $300 to $600 | Fixr, January 31, 2025 |
The written quote sets the price. Plumbers may charge a call-out fee, a minimum or an hourly rate, and the Fixr plumbing guide, updated January 30, 2025, gives typical hourly rates of $75 to $150. Compare quotes that itemize parts, labor, haul-away and any trip fee.
What makes two quotes for one sink differ?
Four factors drive it: the fixture you choose, how much of the existing plumbing must change, how cramped the cabinet is, and the power for a disposal. Hardwired units run cable directly to a junction, plug-in models use a cabinet outlet, and a countertop air switch brings a small button and tubing.
Houses in Downtown Riverside, the Wood Streets and the Eastside may have stiff old shut-off valves or galvanized supply stubs that snap when touched. That adds labor, and a plumber should flag it before opening anything. If no outlet exists under the sink, ask who does the electrical piece, since it can fall to a separate trade.
Mineral buildup matters too: Riverside Public Utilities' 2025 report gives average hardness of 197 mg/L, and crust of that kind can seize old fittings and clog the aerators on an older faucet.
What if the shower is leaking?
A plumber can fix shower valves, replace cartridges, change a shower arm or rebuild a diverter. The guides we read offered no dependable dollar range for shower repair, so wait for the written quote instead of trusting a figure from elsewhere. Common causes appear in shower leaks and a leaking shower faucet.
A spout drip usually comes from a cartridge or seat. Dampness inside the wall behind a tub or shower is more serious, because it can damage framing, so get it checked soon.
Can I do this job myself?
Plenty of owners swap a faucet on their own, since a basic kitchen model is a modest job with basic tools. A disposal is harder because of drain alignment and wiring. The state's $1,000 contractor-license threshold is well above a faucet or disposal swap, though permits can still apply to some plumbing work.
To hand it off, we pass your request to a local plumbing business, and the quote comes in writing before work starts. Other jobs are on the Rubidoux Ridge Plumbing home page.
Common questions
How long should I plan for?
Which questions should I ask the plumber?
Does someone need to be home?
Sources used
Page updated