Start by closing the shutoff valve closest to the leak, or the main when the other cannot be located, and then open the lowest tap so the line empties. Most damage stops within minutes. Next, examine the pipe, since the repair hinges on the material, the size of the hole and its position. The plumber for leaks page describes how a local plumber is arranged to visit you, and leak detection cost helps when the source is hidden.
What are the first steps when a water pipe is leaking?
Turn the water off, empty the line, clear valuables from the wet zone and cut power to any outlets or appliances the water has touched. Photograph the damage for insurance. Then pin down the leak, which may be a visible spray, a joint drip, a wall stain or a damp yard spot.
Learn the location of your main shutoff before an emergency. It normally sits at the point of entry, near the meter or on an outside wall, and a quarter-turn or a wheel valve controls it. Try it once when nothing is wrong, because a main valve that has not moved in years can seize.
Where water comes through a ceiling, keep clear of the spot and leave power off to the lights below. For what to look for, see ceiling water leak signs. When a pipe has split and is flooding, call at once and use the burst pipe emergency plumber page.
What causes pipes to leak in Riverside area homes?
Age, corrosion, high pressure, movement and bad joints are the usual causes, and the mix depends on the house. Older homes may have galvanized steel or copper that is wearing from the inside, and homes from the 1970s to 1990s may have copper or other materials.
Newer houses are more likely to have PEX and plastic drains, which tend to fail at fittings. Hillside homes can see pipe stress from settling or movement. We are not saying a given house has these issues, only that the likely causes shift with age and build.
Pressure is a hidden factor. Static pressure is capped at 80 psi by the California Plumbing Code, and a failed regulator can push pressure beyond that, straining every joint. A gauge test is cheap, and adjusting a water pressure regulator explains how to read one. For galvanized pipe, read galvanized pipe replacement.
Which temporary fixes work on a leaking pipe?
Repair clamps, rubber-and-hose-clamp wraps and epoxy putty hold small leaks for a short time. They suit a pinhole or a split in an exposed pipe while you wait for a plumber, but none is a lasting fix on a pressurized line. Dry the pipe first, because most products need a dry surface to stick.
Choose by pipe and by hole:
- Pinhole in copper. A clamp sized to the pipe, or water-rated epoxy putty, can slow it. Pinholes often mean the pipe is thinning from the inside, so more will follow. See pinhole leaks in copper.
- Split in plastic pipe. Remove the damaged section and fit the correct plastic fittings. The options are explained in how to stop a plastic pipe leak.
- Leaking joint. Dry it, check whether it is a threaded, soldered or compression joint, and tighten only if the metal is sound.
- Leak under a sink. Often a supply line, a nut or a trap. See how to repair a leaking pipe under the sink.
If you use a temporary fix, write down the date and plan the permanent repair soon.
How do I find the leak?
Follow the wetness back to its highest point, since water runs down along pipes and framing. Check joints, valves, fittings and the underside of sinks first. If it stays hidden, run a meter test: switch everything off, note the meter reading, then check it again after two hours. The EPA recommends this two-hour check, and any change means a leak.
A meter that moves while every fixture is off points to a leak in the house or the line from the meter. Toilets are the most common silent source, so add food coloring to each tank and see if color reaches the bowl within ten minutes. The EPA says the average household's leaks waste more than 9,300 gallons of water a year.
For a leak concealed in a wall, a floor or a slab, a plumber uses listening gear, thermal imaging or pressure tests to pin it down. That costs less than opening walls at random. Slab leak detection and repair covers leaks under concrete.
How is a leaking pipe permanently repaired?
The plumber removes the damaged section and puts in new pipe and fittings of the same material, or renews the whole run if the pipe is worn throughout. Copper is soldered or joined with press fittings, PEX uses crimp or expansion fittings, and plastic pipe uses solvent-welded joints. Then the line is pressure tested.
A repair is only as good as the pipe around it. If the pipe next to the leak is corroded, a patch may fail a few inches away. A plumber looks at the full run and says whether a section, a branch or the whole house needs attention. If leaks keep appearing, repiping a house may be the more sensible plan.
Opening walls and floors, then closing them again, is part of the work, and the plumber coordinates with whoever does drywall and finishes. Drying the area matters. Wet insulation and drywall can grow mold, so ask about drying before the wall is closed.
Is a permit or license required for pipe repair?
Fixing a leak at a faucet or toilet is exempt from permits in Riverside, but the city's handout says replacing piping behind the face of a wall or below the floor requires a permit. Call Building and Safety at (951) 826-5800 before starting. A contractor license is required in California for jobs of $1,000 or more, and for any job that needs a permit.
Moreno Valley's Building and Safety Division is at (951) 413-3350 and Loma Linda's permit line is (909) 799-2836. Unincorporated areas use County of Riverside Building and Safety at (951) 955-1800. Emergency repairs happen first, and permits follow, so tell the plumber if the work is urgent.
When the pipe is a gas line, stop. On a gas smell, get out of the building and call SoCalGas at 1-800-427-2200 once outside. Never repair gas piping yourself.
Reach us through the quote page with the leak location and what you see, and see the rest of our services on the home page. For burst pipe repair, see burst water pipe.
Common questions
Can I leave a small pipe leak until next week?
How do I know if a leak is in the wall?
Will homeowners insurance pay for a leaking pipe?
Who repairs a pipe leak in Moreno Valley or Loma Linda?
Sources used
Page updated